MyoWare Muscle Sensor

En sensor som placeras på muskler för att mäta hur många volt den ska outputa. Detta kan användas för att spela simpla spel utan en kontroll.

• kopplingsschema

kodexempel

/*
		ReadAnalogVoltage
		Reads an analog input on pin 0, converts it to voltage, and prints the result to the serial monitor.
		Graphical representation is available using serial plotter (Tools > Serial Plotter menu)
		Attach the center pin of a potentiometer to pin A0, and the outside pins to +5V and ground.
		This example code is in the public domain.
		*/
		// the setup routine runs once when you press reset:
		void setup() {
		// initialize serial communication at 9600 bits per second:
		Serial.begin(9600);
		}
		// the loop routine runs over and over again forever:
		void loop() {
		// read the input on analog pin 0:
		int sensorValue = analogRead(A0);
		// Convert the analog reading (which goes from 0 – 1023) to a voltage (0 – 5V):
		float voltage = sensorValue * (5.0 / 1023.0);
		// print out the value you read:
		Serial.println(voltage);
		}